Explore our new Cybersecurity Terms Glossary, explained by our experts.
Cybersecurity Terms Glossary
WEP, WPA, WPA2, and WPA3 are the successive security protocols for Wi-Fi. Each replaced a predecessor that had been broken, and the differences decide whether your wireless traffic is readable.

What Are WEP, WPA2 and WPA3?
Wireless traffic is broadcast to anyone within range, so Wi-Fi has always needed encryption to be usable at all. The protocols that provide it arrived in four generations, each prompted by the failure of the one before. Knowing which generation your network runs, and in which mode, is the difference between a wireless segment that resists an attacker in the car park and one that does not.
Wired Equivalent Privacy used the RC4 stream cipher with a 24-bit initialisation vector prefixed to a 40-bit or 104-bit key. The initialisation vector was too short, so on a busy network values repeated within hours, and the way RC4 was keyed leaked information about the key itself. The FMS attack of 2001 exploited that leak, and the PTW attack of 2007 reduced key recovery to roughly 40,000 captured packets and a few seconds of computation.
Today aircrack-ng recovers a WEP key faster than most people can read the manual. The IEEE deprecated it in 2004, and the PCI Security Standards Council banned it outright for cardholder data environments from 30 June 2010. If you find WEP on a network, it is attached to a device that should have been retired years ago.
Wi-Fi Protected Access was designed to run on the same hardware as WEP, so it kept RC4 and added the Temporal Key Integrity Protocol: per-packet key mixing, a longer initialisation vector, and a proper integrity check. It did its job as a transitional measure and was itself attacked from 2008 onwards. TKIP should not appear in any current configuration.
Ratified as IEEE 802.11i, WPA2 replaced RC4 with AES in CCMP mode, which remains cryptographically sound two decades later. Its weaknesses are in the surrounding protocol rather than the cipher:
WPA3 keeps AES and replaces the part that was failing. Simultaneous Authentication of Equals, a password-authenticated key exchange, makes offline dictionary attacks infeasible — each guess requires a fresh interaction with the network — and provides forward secrecy, so a passphrase recovered later does not decrypt previously captured traffic. Protected Management Frames are mandatory, which closes deauthentication flooding. WPA3-Enterprise adds an optional 192-bit mode for high-assurance environments, and Wi-Fi Enhanced Open brings opportunistic encryption to guest networks that have no password at all.
Two caveats matter. The Dragonblood research of April 2019 found side channels in the original password derivation and showed that WPA2/WPA3 transition mode permits a downgrade, since an attacker can present a WPA2-only network and capture a handshake. The derivation issue was addressed by the hash-to-element method; the transition mode issue is structural, so move to WPA3-only as soon as the client estate allows. Separately, the FragAttacks disclosed in May 2021 affect frame fragmentation and aggregation across all versions, including WPA3, and were fixed through vendor patches.
| Setting | Recommendation |
|---|---|
| Protocol | WPA3-only where clients allow; otherwise WPA2 with CCMP and PMF set to capable |
| Corporate access | WPA3-Enterprise or WPA2-Enterprise with EAP-TLS and certificate validation enforced |
| Passphrase (personal) | Long and random, treated as a credential with an owner and a rotation date |
| Guest network | Enhanced Open, isolated, with no route to internal systems |
| Never enable | WEP, TKIP, and WPS |
For organisations handling card data, PCI DSS requires strong wireless cryptography and regular detection of unauthorised access points, and the NCSC’s device security guidance expects enterprise authentication rather than a shared passphrase. Wireless configuration review and rogue access point testing form part of our Penetration Test Services.
Where every client supports it, yes, because transition mode allows an attacker to force a WPA2 handshake and attack it offline. The obstacle is usually embedded equipment: printers, cameras, industrial handhelds, and older controllers that will never support WPA3. A common approach is a WPA3-only network for modern clients and a separate, isolated WPA2 network for the devices that cannot move.
Long enough that a dictionary and rule-based attack fails, which in practice means at least twenty characters of genuine randomness rather than a memorable phrase. Attackers run captured handshakes against enormous wordlists and mutation rules on GPU hardware. Better still, move to enterprise authentication so there is no shared passphrase for anyone to capture and crack.
No. WPA3 protects the link between the client and the access point, nothing beyond it. Traffic is decrypted at the access point and travels onward under whatever protection the application provides. On networks you do not control, a VPN still matters, as does TLS everywhere. WPA3 removes the specific risk of an eavesdropper reading your wireless traffic.
With CCMP, Protected Management Frames enabled, enterprise authentication, and patched clients, WPA2 remains defensible for most environments. What is not acceptable is WPA2-Personal with a weak shared passphrase, TKIP left enabled for compatibility, or unpatched clients still vulnerable to KRACK. Treat WPA2 as the fallback you are actively migrating away from.
You May Be Interested In These
We use a few cookies that are needed to make this website work, and they are always on. We would also like to set analytics cookies, to see which pages are useful; functional cookies, so that our live chat works; and advertising cookies, to measure our campaigns. We will not set any of those until you say yes, and you can change your mind at any time from the Cookie Settings link in the footer.
Choose the cookies you are happy for us to use. Strictly necessary cookies are always on; everything else is off until you turn it on.
These cookies keep the website working: they hold your security checks, your form submissions and the choice you make here. The site cannot run without them, so they are always on.
These let our live chat open and remember your conversation, and let the newsletter sign-up work. Switch them off and the chat window will not appear.
These tell us which pages are read and how people find us, so that we can improve the site. The reports are about groups of visitors, never about you personally.
These let us measure our advertising and show you our adverts on other websites, such as LinkedIn, Google and Meta. Switch them off and you will still see adverts, but they will be less relevant.