Explore our new Cybersecurity Terms Glossary, explained by our experts.

View the Glossary View the Glossary
PRIVIA

Cybersecurity Terms Glossary

What Is Software-Defined Radio?

Software-defined radio moves signal processing from fixed hardware into software, letting a single inexpensive device receive, analyse, and in some cases transmit across a very wide range of frequencies.

Illustration for the cybersecurity term Software-Defined Radio
Home / Blog / Cybersecurity Terms / What Is Software-Defined Radio?
17 November 2026

What Is Software-Defined Radio?

What Is Software-Defined Radio?

A conventional radio is built for one job. Its filters, mixers, and demodulators are physical components chosen for a specific band and modulation, and changing any of that means changing hardware. A software-defined radio pushes that boundary as close to the antenna as practical: it digitises a slice of spectrum and hands the samples to software, where demodulation and decoding become code rather than circuitry. One device, reprogrammed, becomes a receiver for anything within its range.

For wireless security work this is transformative. An assessor no longer needs a vendor’s proprietary development kit to look at a proprietary protocol. They need an antenna and a laptop.

The Hardware

Antenna choice matters more than people expect. A device that appears to have no signal at 868 MHz usually has the wrong antenna attached rather than a hardware fault.

The Analysis Workflow

  1. Survey. Sweep the likely bands while operating the target device and watch the waterfall display in GQRX or SDR++ for bursts that correlate with your button presses.
  2. Capture. Record the raw complex samples to a file so the analysis is repeatable and nothing depends on persuading the device to transmit again.
  3. Identify the modulation. Amplitude shift keying, frequency shift keying, and Gaussian FSK dominate sub-GHz devices, and each has a distinctive appearance in the time and frequency domains.
  4. Demodulate and extract bits. Universal Radio Hacker is the practical tool here, combining capture, demodulation, protocol inference, and fuzzing in one interface. Inspectrum helps when the timing needs picking apart manually.
  5. Reason about the protocol. Compare captures of the same action to see which bytes are fixed, which are a counter, and which are a checksum. Fixed payloads mean replay works; a changing counter means a rolling code.

GNU Radio sits underneath much of this for anyone building a custom receiver chain, and rtl_433 already decodes several hundred consumer sensors, so it is worth trying before writing anything.

What It Finds

The recurring finding in product assessments is that a proprietary sub-GHz link has no cryptography at all — a static code transmitted in clear, which a replay reproduces exactly. Garage doors, older car remotes, alarm sensors, industrial remote controls, and tyre pressure monitors have all been shown to work this way. Rolling codes improve matters but have their own failure modes; the RollJam technique demonstrated by Samy Kamkar in 2015 jammed the receiver while capturing two successive codes, replaying the first and keeping the second in reserve.

SDR also underpins analysis of protocols covered elsewhere in this glossary, from Zigbee and LoRaWAN to pager traffic and ADS-B aircraft telemetry — and it is a standard way of demonstrating that an industrial site’s wireless telemetry is readable from the car park.

Transmitting: the UK Legal Position

Receiving and transmitting are not equivalent in law. In the United Kingdom, establishing or using wireless telegraphy apparatus without a licence is an offence under section 8 of the Wireless Telegraphy Act 2006, subject to the licence exemptions Ofcom sets for short-range devices in bands such as 433 MHz and 868 MHz, each with its own power and duty cycle limits. Deliberate interference is separately an offence under section 68. Replaying a captured signal on a licensed band, or jamming anything, is not a grey area.

Practically: do transmit testing in a shielded enclosure or at minimal power on an exempt band, keep the authorisation in writing, and remember that the Computer Misuse Act 1990 applies when the device you are commanding belongs to someone else. Our IoT Penetration Test Services scope radio testing against these constraints before any engagement starts.

FAQ – Frequently Asked Questions

What SDR Should I Start With?

An RTL-SDR dongle and a decent antenna. It costs about £25, covers the bands where most consumer and industrial devices operate, and teaches the whole receive-side workflow. Move to a HackRF One or similar only when you need to transmit or work above 1.7 GHz, by which point you will know what specification actually matters for your work.

Is It Legal to Listen to Radio Signals in the UK?

Receiving is broadly permissible for general reception, but the Wireless Telegraphy Act 2006 makes it an offence to use apparatus with intent to obtain information about the contents of a message you are not authorised to receive, and to disclose such information. In practice, capture signals from equipment you own or are authorised to test, and keep the authorisation documented.

Can SDR Break Encrypted Wireless Protocols?

No. SDR gives you access to the raw signal and therefore the ciphertext; it does not help with the cryptography. Its value is in finding protocols that have no encryption, identifying weak implementations such as static codes or predictable counters, and capturing the material needed for analysis of the key exchange, which is often where the actual weakness lies.

How Do I Know Which Frequency a Device Uses?

Start with the regulatory marking. UK and EU products carry an identifier whose database entry lists the operating frequency, and the FCC equivalent is often printed on the same label. Failing that, sweep the licence-exempt bands at 433 MHz, 868 MHz, and 2.4 GHz while operating the device, and look for bursts that appear exactly when you press the button.

Related Terms

You May Be Interested In These

What Is Physical Imaging of a Mobile Device?

Cybersecurity Terms

17 November 2026

What Is Physical Imaging of a Mobile Device?

Read More
How the SolarWinds Orion Backdoor Worked

Cybersecurity Terms

17 November 2026

How the SolarWinds Orion Backdoor Worked

Read More
What Is Penetration Test Reporting?

Cybersecurity Terms

17 November 2026

What Is Penetration Test Reporting?

Read More